If fuel is used at temperatures lower than specified temperature (particularly at temperatures below -15°C (5°F), the fuel will gel-up and solidify. If fuel is used at temperatures higher than specified temperature, the viscosity will drop, and this can cause performance problems. Before starting engine, or when 10 minutes have passed after adding fuel, drain sediment and water from fuel tank. If engine runs out of fuel, or if filters have been replaced, it is necessary to bleed air from circuit. If there is any foreign material in fuel tank, wash tank and fuel system.
IMPORTANT Ultra Low Sulfur Diesel (ULSD) fuel 0.0015 percent (S 15 ppm (mg/kg)) sulfur is required by regulation for use in engines certified to nonroad Tier 4 standards (U.S. EPA Tier 4 certified) and that are equipped with exhaust aftertreatment systems. European ULSD 0.0010 percent ( 10 ppm (mg/kg)) sulfur fuel is required by regulation for use in engines certified to european nonroad stage IIIB and newer standards and are equipped with exhaust aftertreatment systems. Using fuels of higher sulfur level can have the following negative effects:
Shorten the time interval between aftertreatment device service intervals (cause the need for more frequent service intervals) Adversely impact the performance and life of aftertreatment devices (cause loss of performance) Reduce regeneration intervals of aftertreatment devices Reduce engine efficient and durability Increase the wear. Increase the corrosion. Increase the deposits. Lower fuel economy. Shorten the time period between Oil drain intervals (more frequent oil drain intervals) Increase overall operating costs. Failures that result from use of improper fuels are not DOOSAN factory defects. Therefore the cost of repairs would not be covered by a DOOSAN warranty.
Inspection, Maintenance and Adjustment 4-9 DX225LC-3