Engine Oil DOOSAN engine oils have been developed and tested to provide the full performance and life that has been designed and built into DOOSAN engines. DOOSAN engine oils that meet API CJ-4 are required for use in the applications listed below. DOOSAN engine oils meeting the API CJ-4 and ACEA E9 oil categories have been developed with limited sulfated ash, phosphorus, and sulfur. These chemical limits are designed to maintain the expected aftertreatment device list, performance, and service interval. If oils meeting the API CJ-4 specifications are not available, oils meeting ACEA E9 may be used.
Doosan Infracore ACEA E9 oils meet the chemical limits designed to maintain aftertreatment device life. CAUTION-OIL SPECIFICATION Failure to meet the listed requirements will damage aftertreatment-equipped engines and can negatively impact the performance of the aftertreatment devices. API CJ-4, ACEA E9 LOW ASH OIL IS REQUIRED The cost of repairs caused by improper engine oils will not be covered by the DOOSAN warranty for your machine. FG021710 Figure 10 The Diesel Particulate Filter (DPF) will plug sooner and require more frequent DPF ash service intervals.
Typical aftertreatment systems include the following; Diesel Particulate Filter (DPF) Diesel Oxidation Catalysts (DOC) Other systems may apply. Therefore the cost of repairs would not be covered by a DOOSAN warranty. Grease Grease is used to prevent seizure and noises at joints. This construction equipment is used under heavy-duty conditions. Always use recommended grease and follow change intervals and recommended ambient temperatures given in this manual. Always wipe off all old grease that is pushed out when greasing. Wipe off old grease where sand or dirt sticking in the grease can cause wear of rotating parts. DX225LC-3 Inspection, Maintenance and Adjustment 4-10