Doosan DX225LC-3 — Change Breaker Filter (Optional)

Change Breaker Filter (Optional) WARNING AVOID DEATH OR SERIOUS INJURY The hydraulic oil will be hot after machine operation. Allow the system to cool down before changing pilot filter. FG021269 Figure 51 1. Park machine on firm and level ground. Lower the front attachment to the ground and stop engine. 2. Tip the hydraulic oil tank breather cap up to release pressure. 3. Locate breaker filter assembly (Figure 51). 4. Position a container under the filter assembly. Remove drain plug and completely drain the assembly. 5. Using a 30 mm wrench, unscrew filter housing from filter head. 6. Remove O-ring from filter head. 7. Replace filter. 8.

Apply a small amount of oil around the entire O-ring and install the filter housing on the filter head. NOTE: Tightening torque: 27 kg m (265 Nm, 195 ft lb) 9. Install drain plug in bottom of filter housing. 10. After changing breaker filter, vent air from pump and check level of hydraulic oil tank. DX225LC-3 Inspection, Maintenance and Adjustment 4-44