Doosan DX225LC-3 — Check Engine Fan and Alternator Belts Wear

Check Engine Fan and Alternator Belts Wear OK WARNING AVOID DEATH OR SERIOUS INJURY OK Keep clear of engine fan and fan drive belts when the engine is running. Contact with rotating belt can cause injury. HAAA4030 Figure 50 WARNING AVOID DEATH OR SERIOUS INJURY When checking, adjusting, or replacing drive belts, precautions must be taken to prevent accidental cranking of the engine. Be sure the starter switch is in the "OFF" position and the controls are tagged. 1. Replace badly worn, greasy, or severely cracked belts immediately. These conditions prevent proper belt function. Visually inspect the belt. Check the belt for intersecting cracks.

Transverse (across the belt width) cracks are acceptable. Longitudinal (direction of belt length) cracks that intersect with transverse cracks are not acceptable. Replace the belt if it is frayed or has pieces of material missing. 2. Before installing new belts, make sure all pulley grooves are clean and not worn. Replace pulley, if damaged, or if the grooves are worn. 3. All pulley support bearings, shafts, and brackets must be in working order. 4. When replacing belts and pulleys, pulley alignment must be checked with belts tensioned and brackets securely clamped. A misalignment that can be visually detected and will reduce belt performance. 5.

Do not force the belts into the pulley grooves by prying with a screwdriver or pry bar. This will damage the belt side cords which will cause the belts to turn and result in severe belt damage or breakage during operation. 6. Belts on new machines and replacement belts lose their tension as they seat into the pulley grooves. Check the tension of new belts at 50 hour intervals until tension is stabilized and thereafter, every 250 hours. If the tension falls below the required minimum, the belt can slip damaging the belts and pulley grooves. NOTE: When operating in abrasive conditions, check belt tension every 100 hours. Inspection, Maintenance and Adjustment 4-43 DX225LC-3