Doosan DX225LC-3 — Grease Swing Gear and Pinion

500 HOUR / 3 MONTH SERVICE Perform All Daily, 50 and 250 Hour Service Checks Grease Swing Gear and Pinion WARNING AVOID DEATH OR SERIOUS INJURY Greasing swing gear and pinion must be done by only one person. 1. Remove inspection cover and inspect the condition of the grease. Inspect for water or other contaminants on the gear teeth. NOTE: The upper structure must be rotated a little at a time so the entire face of the swing gear can be lubricated. Use extreme caution when performing this operation. Figure 52 2. If water or other contaminations are found, remove lower access cover so the gear teeth can be thoroughly cleaned and lubricated. 3.

Install access covers after lubricating gear teeth. FG018327 Figure 53 DX225LC-3 Inspection, Maintenance and Adjustment 4-46 FG020078 FG0200 78