Doosan DX225LC-3 — Change Engine Oil and Filter

Change Engine Oil and Filter NOTE: Change engine oil and filter after first 50 hours of operation or rebuild, then every 500 thereafter. WARNING AVOID DEATH OR SERIOUS INJURY DO NOT change oil on a hot engine. Allow the engine to cool down before attempting to change the engine oil and filter to avoid burns by touching hot engine parts. 1. Position a larger container under the engine. Remove cap (1, Figure 54) and install hose (2) to drain the engine oil. Remove hose (2) and install cap (1). NOTE: Dispose of drained fluids in compliance with all applicable environmental laws and regulations.

1 2 IMPORTANT Dispose of filters/oils/liquids in compliance with all applicable environmental laws and regulations. Figure 54 FG000144 2. Replace engine oil filter by using filter wrench. The engine oil filter is a spin-on type. See Figure 55. Remove and discard filter. 3. Install new filter. Apply a small amount of oil around filter gasket. Screw filter on head until gasket contacts head, turn filter 1/2 turn more. FG021403 Figure 55 4. Refill the engine with the correct oil through the oil fill port (Figure 56). Refer to the Lubrication Table of this manual for the recommended oil for the operating conditions. NOTE: See “Fluid Capacities” on page 4-18. for capacity. 5. Start engine.

Run engine for five minutes at "LOW IDLE" and check engine oil pressure light. 6. Stop engine. Look for signs of leaks at filter. Recheck oil level after fifteen minutes. FG019582 Figure 56 Inspection, Maintenance and Adjustment 4-47 DX225LC-3