DX225LC-3 Inspection, Maintenance and Adjustment 4-54 Change Main Fuel Filter WARNING AVOID DEATH OR SERIOUS INJURY Change filter after waiting for engine to cool. Be careful of fire hazards. Do not smoke. 1. Locate fuel filter inside engine compartment. FG021267 Figure 73 2. Position a small container under fuel filter. 3. Unscrew fuel filter from head assembly. Discard fuel filter. NOTE: Dispose of drained fluids in compliance with all applicable environmental regulations. 4. After cleaning filter head, install new fuel filter. Screw filter on head until gasket contacts head, and turn filter 1/2 turn more with a filter wrench. NOTE: Coat fuel filter gasket with fuel. NOTE:
Fill fuel filter with clean fuel. This will help reduce fuel system priming. FG000478 NOTE: Only use Ultra Low Sulfur Diesel (ULSD) fuel Figure 74 and API-CJ-4/ACEA-E9 grade engine oil. Fuel System Priming If air remains in the fuel inlet line to the engine, it can cause the 2 engine to run in an abnormal condition. Air may impact the starting capability of the engine, and may also result in surging 1 engine speeds. If the machine happens to have run out of fuel, or if the fuel filter has been replaced, bleed the air out using the following procedure: 1. Stop engine. 2. Check that fuel valve is open. 3. Open fuel drain valve. FG020728 4. Loosen plug (1, Figure 75) on the fuel prefilter head.
Figure 75 5. Pump the hand-operated primer pump (2, Figure 75) on the fuel prefilter. Pump primer until fuel is present at plug hole in fuel prefilter head. 6. Tighten plug (1, Figure 75) in fuel prefilter head. 7. Continue to pump primer pump until a strong resistance is felt. 8. Start engine and look for signs of leaks. 9. Repeat procedure if necessary. FG021267