3. Remove coolant drain plug (2, Figure 110) from engine. 4. Install drain plug, and close drain valve after coolant has completely drained from system. 2 6. Run engine at "LOW IDLE" until coolant temperature gauge reaches the "WHITE ZONE". Run engine for another ten minutes. 5. Fill cooling system with a flushing solution. 7. Allow engine to cool. 8. Drain flushing fluid and fill system with water. FG019632 9. Run engine again to allow water to completely circulate. Figure 110 10. After allowing engine to cool, drain water and fill system with proper antifreeze solution for ambient temperature. Refer to coolant concentration table. See “Antifreeze Concentration Tables” on page 4-94. 11.
Run engine without radiator cap installed, so all air will be purged from system. Fill radiator to fill neck. 12. Drain and fill radiator coolant recovery tank. ChangeAir Compressor Filter (Optional) 1. Open the door of the battery box on the right side of the machine. 2 2. Remove filter cap (1, Figure 112) manually, remove air filter (2, Figure 111) in the housing, and clean the cap and inside (3, Figure 112) of the housing. 3. Replace the air filter (2, Figure 111), and assemble the filter cap (1, Figure 112). Figure 111 FG015679 3 WARNING AVOID DEATH OR SERIOUS INJURY 1 Do not try to clean or replace the filter while the air compressor is running.
Wear safety goggles to protect your eyes from flying dust when cleaning or replacing the filter. Figure 112 FG019407 Inspection, Maintenance and Adjustment 4-69 DX225LC-3