Change Radiator Coolant NOTE: Do not mix ethylene glycol and propylene glycol antifreeze together. See “Engine Cooling System” on page 4-92, for further details. WARNING AVOID DEATH OR SERIOUS INJURY Allow the engine to cool before releasing the radiator cap. Make sure to loosen the cap slowly to release any remaining pressure. Figure 108 ARO1760L Radiator cleaning is performed while the engine is running. Take extreme caution when working on or near a running engine. Make sure to lock out and tag the controls notifying personnel that service work is being performed. Do not remove radiator cap unless it is required. Check the coolant level in the coolant recovery tank.
IMPORTANT Do not mix up the antifreeze from different makers. Mixing the two compounds can cause generation of foreign material which can damage the system. Therefore, it Is recommended to use authorized DOOSAN genuine antifreeze solution. To achieve the best cooling performance, keep the mixing ratio of the antifreeze and water by 50 : 50. Using water only can corrode the coolant circuit. In bitterly cold working conditions, the customer should frequently check the performance of the coolant for appropriateness for the weather and then determine change cycle of the coolant. 1. Slowly open the radiator cap to allow any pressure to escape. 2.
Place a container under the radiator and open the drain valve (1, Figure 109). NOTE: Dispose of drained fluids in compliance with all applicable environmental laws and regulations. Figure 109 DX225LC-3 Inspection, Maintenance and Adjustment 4-68 1 FG019581 1 FG019581