Doosan DX225LC-3 — Bucket Tooth Replacement

BUCKET Bucket Tooth Replacement WARNING AVOID DEATH OR SERIOUS INJURY Due to the possibility of flying metal objects and to avoid death or serious injury, always wear safety helmet, protective gloves and eye protection when changing bucket teeth. Curl the bucket upwards and place the round rear surface of the bucket firmly on the ground. Stop engine and lock out the hydraulic controls before working on the bucket. NOTE: These instructions are only for DOOSAN OEM, buckets. If you are using other manufacturers buckets, refer to their specific instructions. HAOC680L Figure 146 1. On a routine basis, inspect bucket teeth to make sure that tooth wear or breakage has not developed.

Do not allow replaceable bucket teeth to wear down to a point that bucket adapter is exposed. See Figure 146. 2. To replace a tooth (1, Figure 147), use a hammer and punch to drive locking pin (2) and lock washer (3) out of tooth adapter (4). 4 3. Once worn tooth has been removed, use a putty knife to scrape adapter as clean as possible. 3 2 1 4. Slide new tooth into position and insert lock washer. FG018361 5. Insert locking pin into tooth and use a hammer, to drive pin in until lock washer seats in locking groove. Figure 147 DX225LC-3 Inspection, Maintenance and Adjustment 4-86