WARNING When transporting the machine, know the width, height, length, and weight. AVOID DEATH OR SERIOUS INJURY When loading or unloading the machine, make sure to run the engine at the lowest speed setting and travel at the slowest speed possible. Make sure that ramp being used can handle the weight of the machine. If required, add blocking under the ramp for additional support. Make sure that ramp surface is free of grease, debris, or mud that could cause the machine to slip or slide. Make sure that trailer is parked on firm and level ground before attempting to load/unload the excavator.
If it is necessary to turn the machine while it is on the trailer, make sure to do this at the slowest engine and travel speeds possible. Make sure to secure the excavator onto the trailer as required by local transportation laws and regulations. 1. Make sure that trailer is parked on firm and level ground. See Figure 5. 2. Make sure that ramps that are being used are designed to handle the weight of the excavator. If required, add blocking under the ramp to provide additional support. 90 ~ 110 3. The ramp angle must be less than a 15° angle. Ramps steeper than this can cause traction or stability problems when loading or unloading. FG018618 15 Figure 5 4.
Set the travel speed selector switch to "O" (OFF) position. See Figure 6. O I II Figure 6 FG016016 DX225LC-3 Transportation 5-4