Doosan DX225LC-3 — Lifting Machine

LIFTING MACHINE 1 1 WARNING AVOID DEATH OR SERIOUS INJURY Never lift the machine with a person in the cabin or on the machine. Never enter the area under or around a raised machine. Improper lifting can allow load to shift and cause death or serious injury or property damage. When lifting, move the safety lever to "LOCK" position to prevent the machine from moving unexpectedly. Use only properly rated cables and slings Never go in the area under or around the machine when it is raised. Always use the posture given in the procedure below and use the proper lifting equipment to lift the machine. EX1300751 Figure 16 1.

Refer to "Specification" section of this manual for weight and dimensional information. 2. Lower the work equipment to the ground as shown in the diagram on the right 3. Lower the dozer blade to the ground. (if equipped) 4. Move safety lever to "LOCK" position. Stop engine. 5. Ensure that there is nothing around the operator's compartment, close the cab door and front glass securely. 6. Bind wire ropes between the 1st and 2nd track rollers from the front and between the 1st and 2nd track rollers from the rear. 7. Use spreader bars between the wire rope and the machine to prevent damage to the rope or machine. Set the lifting angle (1, Figure 16) of the wire rope to 30° - 40°. 8.

After the machine comes off the ground, check the hook condition and the lifting posture, and then lift slowly. DX225LC-3 Transportation 5-8