Troubleshooting 6-1 DX225LC-3 Troubleshooting 6 Whenever an operating problem with the machine occurs, take corrective action immediately by checking for the cause of the problem. If the cause of the operating problem cannot be determined, contact your DOOSAN distributor. Never perform an adjustment or the disassembly of the hydraulic, electrical or electronic components without first contacting a DOOSAN distributor. WARNING AVOID DEATH OR SERIOUS INJURY Instructions are necessary before operating or servicing machine. Read and understand the Operation and Maintenance Manual and signs (decals) on machine.
Follow warnings and instructions in the manuals when making repairs, adjustments or servicing. Check for correct function after adjustments, repairs or service. Untrained operators and failure to follow instructions can cause death or serious injury. ELECTRICAL SYSTEM Problem Cause Correction Battery will not hold a charge. Low battery power. Clean and retighten. Alternator belt loose or bad. Tighten or replace belt. Loose or corroded terminals. Tighten or replace as required. Alternator faulty. Repair or replace as required. Low battery power. Internal battery short. Replace battery. Short-circuit in wiring. Repair as required. Engine speed is not controllable. Speed control dial failed.
Replace control dial. Throttle controller failed. Replace controller. Speed control motor failed. Repair or replace as required. Blown fuse. Replace fuse. Wiring harness damaged. Repair or replace as required. Connector failed. Repair or replace as required.