The following rated loads are in compliance with ISO 10567 and applicable ISO standards for hydraulic excavators performing lifting operations on firm supporting surfaces. An asterisk (*) next to the load rating indicates rated load does not exceed 87% of hydraulic capacity. All other ratings do not exceed 75% of tipping capacity. Do not attempt to lift or hold any load that exceeds rated load capacity at the specified distances (from the machine's rotation centerline and height - see "Lifting Radius" and "Lifting Point Height" in the reference drawing, Figure 9).
Centerline of Rotation Lifting Radius Lifting Point Lifting Point Height Ground Line (Machine Supporting Surface) FG018603 Figure 9 The weight of slings and any auxiliary lifting device (and/or the weight difference of any attachment heavier than standard configuration) must be deducted from the rated lift capacity to determine net lifting load. The lift point must be on the end of the arm, as shown in Figure 9. IMPORTANT Select the Digging Mode switch on the Instrument Panel before using the excavator for lifting work. Engine and hydraulic oil should both be fully warmed up to operating temperature before operating. Specification 7-11 DX225LC-3