Never turn starter switch to "O" (OFF) position when traveling. This can lead to a loss of steering control. Travel Position Do not operate attachments while traveling. Do not change selected travel mode (FAST/SLOW) while traveling. Never travel over obstacles or excessive slopes that will cause machine to tilt severely. Avoid any slope or obstacle that can cause machine to tilt 10° or more to right or left, or 30° or more from front to rear. 40 - 50 cm (16 - 20 in.) Do not operate steering controls suddenly. Work equipment can hit ground and this can damage machine or structures in area. When traveling on rough ground, travel at low speed, and avoid sudden changes in direction.
Always operate within permissible water depth. Permissible water depth is up to centerline of upper track roller(s). When passing over bridges or structures on private land, check that structure is strong enough to support weight of machine. Before traveling on public roads, check with appropriate authorities and follow their instructions. Figure 30 FG018461 Never exceed maximum permitted load for bridges. Always operate machine with idler wheels to front under cabin and drive sprockets to rear. Know permitted ground pressure. Ground pressure of the machine may change depending on attachment and load. Keep height and length of attachment in mind. DX225LC-3 Safety 1-40