Doosan DX225LC-3 — Operation In Extreme Cold

Operation in Extreme Conditions Operation In Extreme Cold In extremely cold weather, avoid sudden travel movements and stay away from even slight slopes. The machine could slide down the slope. Snow accumulation could hide potential hazards and slippery surfaces. Warming up engine for a short period may be necessary to avoid operating with sluggish or reduced working capacity. The jolting shocks and impact loads caused by bumping or bottoming boom or attachment could cause severe stress in very cold temperatures. Reducing work cycle rate and workload may be necessary. If machine is to be operated in extremely cold weather temperatures, certain precautions must be taken.

The following paragraphs detail checks to be made to be certain machine is capable of operating at these temperatures. 1. Preheat the engine before startup. Preheat the engine before startup. Wait 3 to 4 seconds after preheating until voltage of the battery return, and then actuate the key switch. 2. Keep batteries fully charged to prevent freezing. If distilled water is added to batteries, run engine at least one hour to mix electrolyte solution. When temperature drops below -10°C, efficacy of the battery is reduced accordingly. Insulation of the battery prevents reduction of efficacy, and supports improvement of starting power of the starter.

WARNING AVOID DEATH OR SERIOUS INJURY Explosion of the battery can cause serious injury or death. Never attempt to directly heat the battery with open fire. 3. Keep engine in good mechanical condition for easy starting and good performance during adverse weather. 4. Use engine oil with proper specifications for expected temperatures. Refer to “Table of Recommended Lubricants” on page 4-19, in this manual or Shop Manual for details. 5. Always keep the fuel tank fully filled after completion of the operation. Always drain water from the fuel tank before and after the operation. In addition, check the water separator, and drain it if required.

The fuel filter, if frozen, may interrupt the flow of fuel. Periodically remove water from the fuel tank, drain water from the filter, and replace the DX225LC-3 Safety 1-68