2. Use care when servicing fuel system to prevent dust and sand from entering tank. 3. Service air cleaner at frequent intervals, check air restriction indicator daily and keep dust cup and dust valve clean. Prevent dust and sand from entering engine parts and compartments as much as possible. 4. Lubricate and perform services outlined on current lubrication chart on machine and “Lubrication and Service Chart” on page 4-16. Clean all lubrication fittings before applying lubricant. Sand mixed with lubricant becomes very abrasive and accelerates wear on parts. 5. Protect machine from dust and sand as much as possible. Park machine under cover to keep dust and sand from damaging unit.
Operation in Rainy or Humid Conditions Operation under rainy or humid conditions is similar to that as in extreme heat procedures previously listed. 1. Keep all exposed surfaces coated with preservative lubricating oil. Pay particular attention to damaged or unpainted surfaces. Cover all paint cracks and chip marks as soon as possible to prevent corrosive effects. Operation in Saltwater Areas Saltwater and saltwater spray is very corrosive. When operating in saltwater areas, or in or around snow, observe the following precautions: 1. When exposed to saltwater, dry machine thoroughly and rinse with freshwater, as soon as possible. 2.
Keep all exposed surfaces coated with preservative lubricating oil. Pay attention to damaged paint surfaces. 3. Keep all painted surfaces in good repair. 4. Lubricate machine as prescribed on lubrication chart on machine or “Lubrication and Service Chart” on page 4-16, in this manual. Shorten lubricating intervals for parts exposed to salt water. 5. Check operating controls to ensure proper functionality and that they return to "NEUTRAL" when released. Safety 1-71 DX225LC-3