Dig - 64 XT855 Operator’s Manual p Setup Dumping Bucket Use right and left joysticks to control excavator dipper, boom, and bucket. 1. Position unit. Position unit between material to be loaded and back end of truck, if possible. Position unit to minimize the need for travel. 2. Fill bucket. 3. Dump bucket. Swing boom into position over truck. Swing boom into position over dump site. Raise boom above truck bed. Move dipper out and open bucket. Move dipper out and open bucket. Swing boom back into position over fill site. Swing boom back into position over fill site. 4. Continue filling and dumping buckets. 5. Reposition unit as needed to complete job. IMPORTANT:
If operator is facing excavator when driving, unit movements are reversed. 6. When job is finished, stow excavator, pivot seat to face tool carrier end, switch unit into tool carrier mode and drive away from area. CMW Onto truck Into hole or onto ground Onto truck Into hole or onto ground