3 - 8 TROUBLESHOOTING Fault status lnspect~onm ethod Judgment-estimated cause-action 1 . The vehicle does not move at all or moves very slowly. (Failure of power transmission by clutch) 1 . 1 Inspect the main pressure. Check both in the case of shifting to forward or reverse and at the neutral state. Standard: (See the measurement-test section.) - Oil level check Check by the level gage. I. 1 .a The oil pressure in the neutral state is lower than the standard. - Regulator valve sticking Check foreign matter trapping, etc., and wash the regu- lator valve.
Break down or fatigue of regulator valve spring-+Replacement Oil pump malfunction 8 1 Oil pump defect-+Replacement 2 Damage of extension sleeve- Replacement Defect in suction line 8 - 1 Clogged oil strainer Replacement - 2 Air suction Check the O-ring or gasket at each joint. Clogging of oil leakage in the oil path be- tween the pump and control valve-+Oil - path inspection Check the O-ring and/or replace the gasket. 1 . 1 .b Abnormally high hydraulic pressure Clogged orifice or sticking of regulator - valve Valve inspection and washing I. 1 .c. The hydraulic pressures (clutch pressures) for both forward travel- ing and reverse traveling are both below the standard.
(Normal in neu- tral state) - Sticking of inching valve spool Check foreign matter trapping, etc. and wash. lnching lever sliding motion defect+ Repair or replace. - Inching rod return defect Inspect and/or replace the rod Ilnk. - Modulator valve sticking Check foreign matter trapping, etc. and wash. - Clogged orifice valve Washing 1 . 1 .d The hydraulic pressure (clutch pres- sure) is lower than the standard for either forward traveling or reverse traveling. See item 1.2 below. 1.2 lnspect the clutch pressure. Standard: (See the measurement-test section.) The clutch pressure is slightly lower than the main pressure.
1.2.a The main pressure is normal, but the clutch pressure (for both forward traveling and reverse traveling) does not rise at all or is abnormally low. The inching spool is sticking t o close the - oil path. Check foreign matter trapping, etc. and wash.