Fault status Inspection method Judgment-estimated cause-action 1.2.b The clutch pressure in either forward traveling or reverse traveling is low- er than the standard. Oil leak in anywhere between the selec- tor valve and main shaft collar-tOil path inspection+Repair or replacement Worn or broken seal ring (main shaft col- lar)-+Replacement Fallen plug from main shaft oil path +Repair or replacement Damage at clutch piston, broken piston ring, piston freeing, etc.+Overhaul the clutch 1.3 Both the main pressure and clutch pressure are normal.
Clogging in the oil path between the selector valve and clutch piston (oil path in the forward side if forward traveling fails)+Oil path inspection and clogged material removal Clutch piston sticking 1.3.a Mechanical trouble in other part of the transmission (Excessive oil tem- perature rise involving abnormal noise generation is likely t o occur in this case.) Overhaul the torque converter 2. Insufficient grade- ability or tractive force (insufficient power) (due to tor- que converter failure in torque generation) 2.1 Inspect the oil level. Check the level gage. 2.2 lnspect the engine no-load maximum rpm and loaded maximum rpm.
(See the measurement-test section.) Tune up the engine if either speed does not satisfy the standard. (See the engine tune-up section.) 2.3 lnspect the main pressure and clutch pressure. (See the measurement-test section.) If the main pressure or clutch pressure is abnormal, inspect according t o 1.1 and 1.2 above. 2.4 Inspect the stall speed. Carry out a stall test, and measure the engine speed at the time. (Note) Always check the engine output (loaded maximum rpm), main pressure and clutch pressure to confirm that the engine and clutch systems are normal be- fore inspecting the stall speed.
(See the measurement-test section.) (Note) the stall speed may be about 100 rpm above or below the standard above depending on slight performance disper- sions of the engine and torque convert- er as well as delicate matching between them. Therefore, use the standard as a guide- line for defect judgment. Inspect the stall speed and judge whether the defect exists on the convert- er side or clutch side. a. The stall speed is too low (300 rpm or more below the standard).+The one- way clutch of the stator is slip- ping.+Replace the converter ASSY. b . The stall speed is too high.+The clutch is slipping tremendous- ly.+lnspect and replace the clutch parts.