Toyota — Torque Converter

Fault status Inspection method Judgment-estimated cause-action 3. The vehicle does not travel in either the forward or reverse direction. 3.1 Set the shift lever neutral and inspect in which direction the vehicle travels. When the vehicle travels* Clutch seizure-+Disassemble and replace the clutch. When the vehicle does not travel*See 3.2 below. 3.2 lnspect the clutch pressure on the faulty side. (See the measurement-test section.) When the clutch pressure is normal-tClutch slipping or clutch piston sliding motion defect-tDisassemble and replace the clutch. When the clutch pressure is abnormal-+See 3.3 below. 3.3 Inspect the selector valve. Selector valve defect-+Disassemblea nd replace.

When the selector valve is normal-tsee 3.4 below. 3.4 Inspect the main shaft seal ring. Seal ring defect*Replace. When the seal ring is normal *Disassemble the clutch as the clutch system is defective. 4. Excessive time lag at starting 4.1 Depress the accelerator pedal simul- taneously with shifting to judge start- ing delay. (It is desirable to compare with a nor- mal vehicle if any.) 4.2 lnspect the main pressure and clutch pressure. lnspect the clutch pressure rise charac- teristic at the same time. (See the measurement-test section.) When the main pressure and/or clutch pressure is abnormal-tlnspect according t o 1.1 and 1.2 above.

4.2.a When the clutch pressure rise is ab- normal (too slow). Breakdown or fatigue of the modulator valve spring*Disassembly, inspection and replacement Clogged orifice valve*Disassembly, in- spection and washing Clogged orifice of regulator valve+ Disassembly, inspection and washing Inching spool return defect*Foreign matter trapping or breakdown or fatigue of spring* Disassembly, washing or replacement Inching lever sliding motion defectjcorrect or replace the lever. Inching rod return defect-tlnspect and replace the rod link. 4.3 Inspect the oil. Insufficient oil level, clogged oil strainer or air suction*Oil addition, disassembly and washing