Fault status Inspection method Judgment-estimated cause-action 5. Inching defect or jerking (shock generation) 5.1 Inspect inching operation. - Inching rod return defect Inspect and replace the rod link and return spring. * I n c h i n g lever sliding m o t i o n - defect Greasing or replacement - Inching spool return defect Foreign matter trapping, breakdown or fatigue of spring-tDisassembly, washing and replacement 5.2 lnspect the main pressure and clutch pressure. Operate the inching pedal and inspect the clutch pressure variation. (See the measurement-test section.) 5.2.a When the clutch pressure rise characteristic is abnormal lnching spool sticking-tcheck foreign matter trapping, etc.
and wash. Inching lever sliding m o t i o n defect+Greasing or replacement - lnching rod return defect Rod link and return spring inspection and replacement Clogged orifice valve-twashing 5.2.b When the clutch pressure rise characteristic is normal (Inspect the clutch pack.) Breakdown or fatigue of clutch return - spring Disassembly and replacement Clutch piston motion detect -t Disas- sembly, inspection and replacement Clutch plate abnormal w e a r 4 Disassembly and replacement 5.3 After shifting the shift lever, release the inching pedal suddenly t o inspect the shock at starting. Fatigue of camber plate + Disassembly, inspection and replacement 6.
Clutch connecting point is either too high or too low. 6.1 lnspect the oil pressure (clutch pres- sure) at the time of inching. I 6. .a When the inching pressure is too high I Breakdown or fatigue of spring for inch- ing spool No.1 (inching r o d side)-Replacement 6.1 .b When the inching pressure is too low Breakdown or fatigue of inching spool - No. 2 Replacement 7. Overheat 7.1 Inspect the torque converter oil level and oil quality. Inappropriate oil Ievel-tCheck excessive or insufficient oil level and correct it t o the proper level. Air suction-tlnspect the O-ring at each joint.
Moisture content in oil-toil replacement 7.2 lnspect the main pressure, clutch pres- sure and torque converter pressure (outlet pressure). (See the measurement-test section.)