Toyota — Torque Converter

Fault status Inspection method Judgment-estimated cause-action 7.2.a When the main pressure or clutch pressure is lower than the standard lnspect according to 1.1 and 1.2 above. 7.2.b When the torque converter pressure is lower than the standard - Regulator valve sticking Disassembly, inspection and washing Excessive resistance of internal oil path-toil path clogging inspection Clogged oil strainer-tDisassembly, washing and replacement 7.3 lnspect the clutch portion. Set to the neutral posit~ona nd check if the vehi- cle travels or not.

7.3.a When the vehicle travels in either the forward or reverse direction Clutch seizure or damage at clutch - pack Disassembly, inspection and replacement 7.4 lnspect the torque converter portion. Defect in converter portion - Stator sticking Converter ASSY replacement Impeller contact-tJudge by checking the oil filter and replace the converter ASSY if defective. Decreased circulating f l o w rate-. Clogged stator shaft orifice, etc.-tDisassembly, inspection and replacement 7.5 Inspect the transmission portion.

Defect in transmission - Clutch dragging Disassembly, inspec- tion and replacernent Bearing wear or seizure-tDisassembly, inspection and replacement 7.6 Check the use status at the user. Check the operation status by the operator, use status and operating place. Check no push-up, etc. especially by per- forming inching operation. Check if excessive switch-back is per- formed. 8. Abnormal noise is generated. 8.1 lnspect the torque converter portion.

Damaged drive plate+Replacement - Damaged bearing Replacement Contact of impeller (fragment inspection at oil filter)+Converter replacement - Loosened bolt Retightening Damaged gear pump + lnspection and replacement 8.2 Inspect the transmission portion. Dragging noise due t o clutch seizure+ lnspection and replacement - Wear or damage at bearing Inspection and replacement Gear damage+Replacement Spline wear+Replacement