Point Operations [Point 1 I Disassembly: Use the SST and remove the stator shaft bearing and clutch gear (reverse). (in clutch shaft No. 1 only) SST 09950 - 2001 7 Disassembly: Remove the clutch gear bearing. SST 09308 - 0001 0 Reassembly: Install the clutch bearing. SST 09608 - 3501 4 Reassembly: Before installing the clutch gear on the clutch drum, align disc serrations with a screwdriver, etc. [Point 21 Inspection: Measure the clearance between each clutch shaft and seal ring. Limit clearance: 0.2 mm 10.008 in)