Toyota — Torque Converter

MEASUREMENT - TEST 1. Oil level measurement (1 ) Keep the vehicle in horizontal state, set the shift lever in the neutral position, and keep the engine in the idling state. (2) After warming up the engine, keep it running at the idling speed. Measure the oil level with the level gage. The oil level is appropriate if it is between the upper limit (L). If insufficient, add oil through the level gage mount - ing port. (F) and lower limit 2. Oil pressure measurement (1 ) After warming up the engine, measure the idling speed and no - load maximum speed. Note: See the engine speed adjustment section (on page 1 - 1 7).

(2) Stop the engine and jack up the front axle to make the tires (both wheels) float above the ground. (3) Remove the toe board and set an oil pressure gage. If three oil pressure gages are available, it is desirable to measure the main pressure, clutch pressure and tor - que converter pressure at the same time.. (4) Start the engine. With the shift lever set in the neu - tral position, measure the main pressure at each of idling and 2000 rpm, and the torque converter outlet pressure at 2000 rpm. (5) With the shift lever set at each shift position, meas - ure the clutch operating pressure at each of idling and 2000 rpm. Note:

Do not depress the inching pedal while measuring the oil pres - sure. Oil pressure measuring ports I u U A: Main pressure (size PTll8) PT118) C: Clutch operating pressure (size 6: Torque converter outlet pressure (size PT118)