Toyota — Torque Converter

3 - 48 Standard Oil Pressure Values 3. Stall test (1 1 Load a cargo near the allowable maximum load, chock the vehicle front and rear wheels securely and apply the parking brake. Note: Keep the vehicle in perfectly stopped state, and stretch wires to make the vehicle immovable for safety. (2) Warm up the engine, and measure the idling speed and no-load maximum speed. Note: See the engine speed adjustment section (on page 1-1 7). (3) Check the engine output by the maximum speed in loaded state. Method After adjusting the no - load maximum speed, operate I I the tilt lever for backward tilting. Measure the maximum speed at full acceleration in relief state.

Standard The relief down from the no - load maximum speed shall be as follows: Gasoline engine models: 150 - 300 rpm Diesel engine models: 100 - 200 rpm The relief down in the LPG engine model in slightly more than the above values. Judgment If the engine speed drops excessively, engine tune- up defect may be the reason. (4) Start the engine, set the control lever in the forward traveling position, race the engine fully, and measure the stall speed after stabilization.

Idling 2000 rprn - 490 981 - (5.0- 10.0) [71 1421 - 932 1373 (9.5-14.0) [135-1991 Clutch pressure kPa (kg/crn2)[ psi] - 441 834 - (4.5 8.5) [64- 1211 - - [I - 883 1373 (9.0 14.0) 28 1991 Torque converter pressure (outlet pressure) - kPa (kg/crn2)[ psil - - - 200 590 (2 6 ) 130 901 Engine 5K 4Y 1D Z 22 Stall speed rpm 1950 2100 21 50 2100 1