Toyota — Torque Converter

Disassembly Procedure 1 Remove the neutral switch and backup lamp switch (OPT). [Point I] 2 Remove the inching lever. 3 Remove the inching cam lever. 4 Remove the shift lever. [Point 21 5 Remove the shift cam lever 6 Remove the valve body plate cover. [Point 31 7 Remove the valve body plate. [Point 41 8 Remove the regulator valve. 9 Remove the inching valve. [Point 51 1 0 Remove the detent spring and steel ball. 1 1 Remove the selector valve. 1 2 Remove the orifice valve and modulator valve. [Point 61 1 3 Remove the oil seal. [Point 71 Reassembly Procedure The reassembly procedure is the reverse of the disassembly procedure. Note:

When installing the inching cam lever and shift cam lever, apply a thin coat MP grease on the inside of the seal. Coat torque converter oil on each valve reassembly. Point Operations upger cover and oil [Point I Inspection: Inspect the switches. Neutral switch: Normal if turned OFF when depressed. Backup lamp switch: Normal if turned ON when depressed. [Point 21 Inspection: Check the shift lever operating force. Set a spring scale at the tip end of the shift lever t o measure the operating force. The operating force cannot be adjusted. Shift lever operating force (Reference): 34.3 - 53.9 N (3.5 - 5.5 kgfI17.7 - 12.1 Ibfl