Disassembly Procedure 1 Drain torque converter oil. 2 Remove the transmission cover & control valve ASSY. 3 Remove the torque converter ASSY. [Point 11 4 Remove the oil pump Wlstator shaft. [Point 21 5 Remove the front cover. 6 Remove the counter gear No. 1. 7 Remove the counter gear bearing. [Point 31 8 Remove the idle shaft. [Point 41 9 Remove the clutch shaft No. 1 Wlclutch drum No. 1 [Point 51 1 0 Remove the idle gear No. 1 Wlbearing. 1 1 Remove the idle gear No. 1 bearing. [Point 61 1 2 Remove the oil pan. 1 3 Remove the output shaft No. 1 and output gear No. 2 [Point 71 1 4 Remove the output shaft bearing No. 1. [Point 81 1 5 Remove the oil strainer. 1 6 Remove the bearing No.
1 (for clutch shaft No. 1 ). [Point 91 1 7 Remove the output shaft bearing No. 2. [Point 101 1 8 Remove the oil filter. [Point 111 1 9 Remove the magnet. [Point 121 Reassembly Procedure The reassembly procedure is the reverse of the disassembly procedure Note: The tightening torque for each part is as follows: Unit:
N - m (kgf-cm) [ft-lbfl Oil strainer set bolt - - - 9.81 15.69 (100 160) (7.24 11.581 Oil pan set bolt - - - 5.88 7.85 (60 80) (4.34 5.791 Idle shaft - - - 4.90 9.81 (50 100) (3.62 7.241 Idle shaft set bolt - - - 3.92 6.86 (40 70) (2.89 5.061 Front cover set bolt - - - 18.63 30.40 (190 310) [13.75 22.431 Transmission cover (upper cover) set bolt - - - 9.81 15.69 (100 160) L7.24 11.581 Stator shaft set bolt - - - 9.81 15.69 (100 160) L7.24 11.581 Oil pump set bolt - - - 9.81 18.63 (100 190) (7.24 13.751 Transmission output cover set bolt 18.63 -- 30.40 (190 -- 310) L13.75 -- 22.431