Toyota — Torque Converter

3 - 72 [Point 71 Disassembly: Use the service bolt for removal. Service bolt size M 1 0 x 1.25 Reassembly: Adjust the thrust clearances related to the out - put shaft. 1. Place a spacer and shim(s) on the output gear No. 2, and temporarily install the output cover Wloutput shaft. 2. Tap the output shaft with a hammer to eliminate the thrust clearance of the gear, spacer and shim. 3. Set a dial gage on the upper face of the output shaft, and pry upward with a srewdriver to measure the move - ment (thrust clearance). Standard clearance: 0.03 - 0.51 mm (0.0012 - 0.0201 in) 4. If the measured value does not satisfy the standard, select the shims to be used. Shim thickness:

0.9, 1.25 and 1.6 mm (0.035, 0.0492 and 0.063 in) [Point 81 Disassembly: After removing the snap ring with the SST, remove the shaft by tapping its end with a plastic hammer. SST 09905 - 0001 2 Disassembly: Remove the bearing from the output cover. SST 09620 - 3001 0