[Point 51 Disassembly: Extract clutch shaft No. 1 Wlclutch drum No 1 to the converter side. Reassembly: Coat grease on the seal ring and install it at the end of the clutch shaft. Reassembly: Adjust the thrust clearance of clutch shaft NO. 1. 1. Install the shim on the stator shaft and temporarily in - stall the oil pump Wlstator shaft. 2. Set a dial gage on the front end of the clutch shaft, and measure the thrust clearance by moving the clutch drum t o and fro. - 0.62 mm (0.0079 - 0.0244 in) Standard clearance: 0.20 3. If the measured value is not within the standard range, select and change the shim thickness at the stator shaft. Shim thickness:
0.71, 0.9, 1.12 and 1.4 mm (0.0280, 0.035, 0.0441 and 0.055 in) [Point 61 Disassembly: SST 09308 - 0001 0 Reassembly: SST 09620 - 3001 0