Reassembly Procedure The reassembly procedure is the reverse of the disassembly procedure. Note: Coat grease on the seal ring before reassembly. After washing each part, coat torque converter oil sufficiently before reassembly Bearing pressing side Point Operations [Point 11 Disassembly: The clutch gear bearing cannot be removed. Always replace the bearing with the clutch gear as a set. Reassembly: When pressing the bering into the gear, slowly push it with a press and make sure that the snap ring at the center of the bearing fits securaly into the gear groove. Reassembly: Before installing the clutch gear on the clutch drum, align disc serrations with a screwdriver, etc.
[Point 21 Inspection: Measure the clearance between each clutch shaft and seal ring. Limit clearance: 0 . 2 mm (0.008 in) [Point 31 Inspection: Measure the clutch disc thickness. Standard thickness: 2.6 mm (0.102 in) Limit thickness: 2.3 mm (0.091 in)