3. If the measured value does not satisfy the standard, select and use an appropriate backing plate. Backing plate thicknes: 4 - disc specification: A = 7.8 and 8 . 3 mm (0.307 and 0.327 in) 5 - disc specification: A = 3.0 and 3.5 mm (0.1 18 and 0.138 in) [Point 41 Disassembly~Reassembly: SST 09220 - 22000 - 7 1 Inspection: Measure the free length of the clutch return spring. Free length: 63.4 mm (2.496 in) Limit free length: 58.5 mm (2.303 in) [Point 51 Inspection: Measure the clearance between the clutch piston and piston ring. Standard clearance: 0.17 mm (0.0067 in) Inspection: Clean the check valve installed in the clutch piston by blowing compressed air. Reassembly:
Install the piston ring with its side marked with white paint facing the hydraulic oil pressure side.