Toyota — Transmission

Disassembly Procedure 1 Drain transmission oil. 2 Remove the upper cover. 3 Remove the shift link bracket. [Point 11 4 Remove the back - up lamp cover. [Point 21 5 Remove the 1st and 2nd shift fork shaft. 7 Remove the 6 Remove the steel ball and spring. forwardlreverse shift fork shaft. 8 Remove the forwardlreverse shift fork. [Point 31 9 Remove the steel ball and spring. 1 0 Remove the 1st and 2nd shift fork. [Point 31 11 Remove the oil seal. [Point 41 12 Remove the transmission front cover and rear cover 1 3 Remove the input shaft. [Point 51 1 4 Measure the backlash and thrust clearance. [Point 61 15 Remove the countergear and synchronizer ring ASSY.

[Point 71 17 Remove the shaft speed gear and reverse idle gear. [Point 91 16 Remove the idle gear and idle gear shaft. [Point 81 18 Remove the output gear. [Point 101 19 Remove the oil seal. [Point 111 Installation Procedure The installation procedure is the reverse of the removal procedure. Note: (08833-00070) on the fork shaft taper bolt before installation. The tightening torque for each portion is as follows: Unit:

Coat thread ti g htener N.m(kg-crnllft-lbl Rear cover set bolt 14.71 - 21.57(150 - 220)[10.85 15.921 7 - - Lower rear cover set bolt 14.71 - 21.57(150 - 220)[10.85 - 15.921 Transmission upper cover Set bolt 9.81-15.69(100-160)[7.24-11.581 1 Joint yoke stopper set bolt - - - 35.30 40.21(360 410)[26.05 29.661 Idle gear shaft set bolt - - - 14.71 21.57(150 220)[10.85 15.921 Countershaft lock nut - - - 166.71 225.55(1700 2300)[123.00 166.41 I Front cover set bolt - - - 14.71 21.57(150 220)110.85 15.921 Fork shaft taper bolt I - - - 40.21 53.94(410 5501i29.66 39.791 Shift link bracket set bolt I - - - 29.42 44.13(300 450)[21.71 32.561 , Link shaft stopper plate set bolt - - - 9.81 15.69(100 1601t7.24 11.581