Point Operations [Point 1 I Inspection: Measure the link shaft outside diameter. Standard shaft outside diameter: 15.0 mm (0.591 in) Limit shaft outside diameter: 14.9 mm (0.587 in) 1 For 1st I Reassembly: Do not confuse forwardlreverse shift link and 1st & 2nd speeds & 2nd shift link. Reassembly: Coat MP grease on the link shaft sliding con - tact face. Add grease through the grease fitting after reassembly. [Point 21 Inspection: Check the backup lamp switch conduction. Switch OFF: No conduction (open circuit) Switch ON (depressed state): Conduction [Point 31 Inspection: Measure the shift fork tip end thickness. Standard thickness: 9.7 mm (0.382 in) Limit thickness:
9.2 mm (0.362 in) Reassembly: Do not confuse the forwardlreverse shift fork and 1 st & 2nd shift fork. Inspection: Measure the clearance between the shift fork and clutch hub sleeve. Limit clearance: I .0 mm (0.039 in)