[Point 21 Removal: After removing the axle shaft set bolts, lightly tap the center of the axle shaft flange with a copper hammer for easy removal. Removal~installation: Carefully operate so as not to damage the oil seal. [Point 31 Removal~installation: 1.2 ton series SST 09509 - 55020 3 ton series SST 09509 - 55030 Installation: Adjust the front axle bearing starting torque. 1 1 6 turn and rotate the hub by 4 to 5 turns again. 2. Set a spring scale on the hub bolt and measure the start - ing force. 1. Fully tighten the bearing lock nut, rotate the hub by 4 to 5 turns. Then loosen the lock nut by 111 2 to SST Starting force 1 ton series hub for divided rim:
25.5 - [5.7 - 16.3 Ib] 1 ton series hub for side ring rim: 32.4 - 92.2 N (3.3 - 9.4 72.6N (2.6 - 7.4 kg) Ib] 2.3 ton series: 25.5 - 72.6 N (2.6 - 7.4 kg) kg) L7.3- 20.7 [5.7 - 16.3 Ib] 3. If the measured value does not satisfy the standard above, make adjustment by tightening or loosening the lock nut. 4. Align the lock nut plate stopper hole with the lock nut threaded hole. 5. Coat thread tightener (08833-00070) on the lock nut stopper bolt, and tighten it.