BELL CRANKmTIE ROD REMOVAL - INSTALLATION 1 Rear axle ASSY 6 Bearina,oil seal Removal Procedure 1 Remove the rear axle ASSY. (See page 8-6.) 2 Disconnect the tie rod end (on the steering knuckle side). [Point 11 3 Remove the bell crank pin. [Point 21 4 Remove the bell crank Wltie rod. [Point 31 5 Disconnect the tie rod end, and remove the tie rod. [Point 41 6 Remove the bearing and oil seal from the bell crank. [Point 51 Installation Procedure The installation procedure is the reverse of the removal procedure. Note: 8-6). The tightening torque for each portion is as follows: Unit:
See the note for rear axle ASSY installation (on page N.m (kg-cm)[ft-lb] Tie rod end lock nut - - 117.68 147.10 (1200 1500) [86.82-108.531 Tie rod end castle nut - - 1.2 ton series: 68.65- 98.067 (700-1 000) l50.65- -72 .351 3 ton series: 147.10 19 6.1 3 ( 1 500 2000) I10 8.53 14 4.701