/I Point Operations [Point 1 I Removal: SST 096 10 - 2001 2 [Point 21 Inspection: Measure the bell crank pin outside diameter. Standard outside diameter: 28.0 mm (1.102 in) Limit outside diameter: 27.8 mm (1.094 in) I Shim I [Point 31 Installation: Coat MP grease on both faces of the thrust washer. Installation: Adjust the clearance between the bell crank up - per face and rear axle beam to the following value by changing the shim thickness. Install the shim on the upper side of the bell crank. ~ h r u s t washer Standard clearance: 0.5 mm (0.020 in) or less Shim thickness: 0.5 and 1.0 mm (0.020 and 0.039 in) [Point 41 Removal: SST 096 10 - 2001 2 Installation:
When the tie rod is replaced, install the tie rod with temporary adjustment of the tie rod length (A), and adjust the toe - in after installation. Tie rod length (reference value) 1 ton series : A = 425 mm (16.73 in) 2-3 ton series: A = 448 mm (17.64 in)