[Point 91 Installation: Pay attention to the relative positions of the needle bearing and oil seal in the assembled state. SST 09620 - 3001 0 REAR WHEEL ALIGNMENT TOE - IN ADJUSTMENT Note: Remove the rear axle when measuring or adjusting the toe-in. 1. Set the wheels to the straight traveling state. (1 ) Align the rear axle beam center hole and bell crank side hole, and insert an appropriate round bar in the holes. 2. Put marks on the center of wheels on the left and right sides. 3. Measure the distance between the marks on both wheels with a toe-in gage or a convex rule in parallel with the ground surface.
(On the front side) Measured value = A Then rotate the wheels by a half turn and measure the distance between marks on both wheels on the rear side. Measured value = B Toe - in = A - B + 4 mm + 0.16 in) Standard toe-in: 0 (0 4. If the toe - in does not satisfy the standard, loosen the tie rod lock nut and change the tie rod length by turning the tie rod for adjustment. In this case, make the tie rod length equal on the left and right sides. REAR WHEEL STEERING ANGLE ADJUSTMENT 1. Adjust the rear wheel steering angle by the knuckle stop- per bolt protrusion (dimension C ) .
Knuckle stopper bolt protrusion (reference value) 1 ton series C = 22.6 mm (0.890 in) 2.3 ton series C = 25.0 mm (0.984 in)