[Point 51 Installation: SST 09370 - 1 01 70 - 7 1 SST 09608 - 2001 2 [Point 61 Removal: SST 0961 0 - 2001 2 [Point 71 Inspection: Measure the king pin outside diameter Standard outside diameter: 28.0 mm (1.102 in) Limit outside diameter: 27.8 mm (1.094 in) Installation: Align the king pin cut groove and lock bolt hole, tighten the lock bolt, and lock by tightening the lock nut. [Point 81 Installation: Adjust the steering knuckle starting force. 1. Insert the shim on the upper side of the thrust bearing and install the king pin. 2. Set a spring scale on the tip end of the knuckle and measure the starting force. Starting force: 14.7 - 39.2 N (1.5 - 4.0 kg) [3.3 - 8.8 Ib] 3.
If the measured value does not satisfy the standard, make adjustment by changing the shim. Shim thickness: 0.1-0.2-0.5 and 1.0 mm (0.22, 0.44, 1.1 and 2.2 in)