Installation: Fill grease in the hub and knuckle spindle. Grease Installation: Adjust the rear axle hub starting force. 1. Temporarily tighten the castle nut to a torque of 0.98 [0.72 ft - lbl, and rotate the hub by 3 to 5 turns. N.m (1 0 kg-cm) 2. Set a spring scale on the hub bolt, and measure the start - ing force. Starting force: 1 ton series 14.7 - 39.2 N (1.5 - 4.0 kg) [3.3 - 8.8 Ibl 2 . 3 ton series 14.7 - 44.1 N (1.5 - 4.5 kg) [3.3 - 9.9 Ibl 3. If the measured value does not satisfy the standard, make adjustment by tightening or loosening the castle nut. [Point 41 Hernoval: SST 09950 - 2001 7 Installation: SST 09370 - 20270 - 7 1