Reassembly Procedure The reassembly procedure is the reverse of the disassembly procedure. Note: See the note for front axle shaft, hub installation. (See Page 7 - 10.) Check no oil or grease adhesion on the brake lining and interior surface of the brake drum before reas - sembly. Set the installed brake shoe outside diameter to the value below by tightening the adjusting screw before installing the hub Wlbrake drum. (Set to 1 m m (0.04 in) smaller than the brake drum inside diameter.) Installed brake shoe outside diameter: 253 m m (9.96 in) Coat thread tightener (08833 - 00070) before tightening the brake drum set nuts.
(Applicable when the hub and brake drum are disconnected.) Bleed air from the brake system after reassembly. Adjust the brake performance after reassembly. For adjustment, repeat forward travel and reverse travel of the vehicle, and stop the vehicle each time by depressing the brake pedal. The tightening torque for each portion is as follows: Unit: N-m (kg-cm)[ft-lbl Point Operations [Point 1 I Disassembly,reassembly: SST 095 10 - 3 1 960 - 7 1 Inspection: Measure the free length of the hold down spring. Standard free length: 25.7 m m (1.012 in) Limit free length:
2 3 m m (0.91in) Brake drum set nut (hub bolt set nut) - - - 68.65 88.26 (700 900) 150.65 65.121 Backing plate self lock nut - - 117.68 137.29 (1200 1400) [86.82- 101.291 Wheel cylinder set bolt - - 7.85 11.77 (80 120) [5.79-8.681