Toyota — Brake

[Point 41 Inspection: Measure the free length of the adjuster spring. Standard free length: 79 mm (3.1 1 in) Limit free length: Replace if there is any clearance in the coil. Reassembly: Apply grease on the threaded portion of the adjusting screw and in the cap. Reassembly: Tie a wire at the end of the adjuster spring and set the spring by pulling it with a screw driver. [Point 51 Reassembly: Coat liquid packing (08826 - 00080) on the parking brake cable port of the backing plate to eliminate any clearance. M 1 [Point 61 Inspection: Measure the brake lining thickness. Standard thickness: 5.0 mm (0.197 in) Limit thickness: 1.0 mm (0.039 in) Reassembly:

Coat grease on the illustrated portions (6 places in contact with the shoe rim and an - chor pin) of the backing plate before install - ing the brake shoe.