Toyota — Mast

REMOVAL - INSTALLATION I I 1 Mast in vertical position and fork at the lowermost position 5 Hose Removal Procedure 1 Set the mast vertical and lower the fork to the bottom position. 2 Disconnect the chain. 3 Remove the chain wheel. [Point 11 4 Remove the lift bracket. (Raise the inner mast until it comes off from the lift bracket, and slowly move the vehicle in the reverse direction to depart from the lift bracket. Then stop the engine.) [Point 21 5 Disconnect the overflow hose and high pressure hose.

(Lower the inner mast to the bottom posi - tion and operate the lift lever several times to release the residual pressure in the lift cylinder be - fore disconnecting the hoses.) 6 Slightly hoist the mast. 7 Remove the mast support caps. 8 Remove the tilt cylinder front pin. [Point 31 9 Remove the mast ASSY.