Toyota — Mast

Installation Procedure The installation procedure is the reverse of the removal procedure. Note: Apply MP grease on the interior surface of the mast support bushing, inner surface of the mast sup - port cap and tilt cylinder front pin. Mast support cap set bolt tightening torque: T = 68.65 - 107.87 N.m (700 - 1100 kg - cm) [50.65 - 79.59 ft-lbl If any of the mast ASSY, outer mast, inner mast and lift cylinder is replaced, it is necessary to in - spect and adjust uneven motion of the lift cylinder. See the lift cylinder rod shim adjustment section (on page 13 - 38) for the inspection and adjustment method. Adjust the chain tension. (See page 13 - 1 9.) Point Operations Removal:

Use the SST for removal if the fitting is tight. SST 09950 - 2001 7 Installation: Install the chain wheel with its side having greater radius at the periphery of its hole fac - ing the boss of the mast side pin. [Point 21 , Installation: Adjust the eccentric roller (OPT) after lift bracket installation. (Common to the V and SV masts.) , / 1. Turn the eccentric roller pin in the direction shown in the illustration, and lock with the set nut at the posl- tion where the roller comes into contact with the inner mast. The direction for turning the pins on the left and right sides are the same as illustrated. 2.

(1 994.1 - 1994.7) The pin on the right side is punched with punched " R " mark while the one on the left side has no mark. (1 994.7 - ) The pin on the left side is punched with punched " L " mark while the one on the right side has no mark. 3. As the pin on the right and left sides use lefthand screw and righthand screw, respectively, the set nut tightening direction is the same as the roller pin turning direction in step 1 above.