ADJUSTMENT 1. Place the vehicle on a level floor, and set the mast in the vertical position. 2. Lower the forks to lay them on the floor, and adjust the chain tensions with the adjust - nuts so that the chains are stretched with no slacks. 3. Check the chains for equal tension on the left and right sides. 4. Check that the chains are not twisted. 5. Check that the maximum fork height is as specified. 6. Check to see that the lift bracket will not come into contact with the stopper portion of the top inner mast tie beam when raised fully. FORK REMOVAL 1. Loosen the set bolts (OPT) for preventing the fork from loosening. Note:
Always set the lever for preventing the fork from loosening in the horizontal position after it is used. 2. Position the fork at 20 cm (7.9 in) above the ground. 3. Place a wooden block under the notched portion of the fork rail. 4. Unlock after lifting the fork stopper pin, and shift the fork blades one by one to the center. 5. Gradually lower the fork and remove it. INSTALLATION The installation procedure is the reverse of the removal pro - cedure. INSPECTION 1. Inspect the fork. Fork tip end limit misalignment: 10 mm (0.39 in) Note: If the tip end limit misalignment is exceeded, inspect the bend, fork mounting looseness and lift bracket finger bar distortion for each blade.