Toyota — Mast

SHIM ADJUSTMENT (PREVENTION OF UNEVEN LIFTING) LIFT CYLINDER ROD Note: For double lift cylinders, inspection and adjustment are required to prevent uneven lifting on the left and right sides due to tolerances of parts, etc. The inspection and adjustments must be made whenever any of the following parts is replaced: Lift cylinder ASSY, lift cylinder rod SUB - ASSY, lift cylinder SUB - ASSY, mast ASSY, outer mast SUB - ASSY, and inner mast SUB - ASSY 1. Inspection method Slowly raise the inner mast, and observe the stopping states of the left and right cylinder rods at the moment when the inner mast reaches the maximum height.

(1 Normal case Both the left and right rods stop almost simulta - neously with almost no shaking of the inner mast. ( 2 ) Abnormal case The rods stop with slight difference and the top of the inner mast shakes at the time of stopping. To correct this, add shims to the cylinder that stops first. 2. Adjustment method (1 Raise the inner mast, set the SST t o the outer mast tie beam, and lower the inner mast until it reaches the SST. SST 0961 0 - 22000 - 71 ( 2 ) Remove the set bolt of the cylinder rod end on the side requiring shim adjustment. (3) Slowly lower the lift cylinder rod and disconnect the cylinder rod end. (4) Place shims on the cylinder rod end.

Slowly raise the cylinder rod end into the inner mast. (5) Fix the set bolt of the cylinder rod end. (6) Raise the inner mast for reinspection. (7) Repeat the inspection and adjustment until the num - ber of shims is determined. Shim thickness: 0.5 and 1.0 mm (0.020 and 0.039 in)