1 L ~ f t bracket Removal Procedure 1 Remove the lift bracket. (See removal procedure steps 1 to 4 in mast removal - installation section on page 13-5.) 2 Remove the cylinder rod end set bolt and cylinder bottom set bolt. 3 Disconnect the cylinder rod end. [Point 11 4 Remove the hose cover. 5 Disconnect the hose. 6 Remove the lift cylinder support. [Point 21 7 Remove the lift cylinder ASSY. Installation Procedure The installation procedure is the reverse of the removal procedure. Note: Perform the following operations after installing the lift cylinder: Repeat lifting and lowering to stroke ends without load to bleed the air and to check normal opera - tion.
After the operation check, check the hydraulic oil level and add oil if insufficient. Inspect the lift cylinders for uneven movements and make adjustment if necessary. (See the lift cyl - inder rod shim adjustment section on page 13 - 38.)