Toyota — Oil Pump

Point Operations [Point 1 I Disassembly: Punch a match mark. Reassembly: Align the match marks. Inspection: Measure the bushing inside diameter. Limit inside diameter: 22.23 mm (0.8752 in) Inspection: lnspect the inside surface in sliding contact. Normal = Glossy contact trace on about half on suction side 7- [Point 21 Inspection: Measure the thickness of the side plate. Limit thickness: 2.70 mm (0.1063 in) Inspection: lnspect the side plate sliding contact surface. Normal = Contact trace relatively stronger on the suction side and slight on the discharge side Reassembly: Install the side plate with its grooved side facing the gear. [Point 31 Disassembly: Make a match mark.

Do not damage the gear. Reassembly: Align the match marks. Inspection: Measure the gear shaft outside diameter. Limit outside diameter: 21.95 mm (0.8642 in)