OIL CONTROL VALVE ASSY REMOVAL - INSTALLATION Note: Before disconnecting the control lever link, release the residual pressure in the material handling sys - tem piping by operating the control lever, set the mast in the neutral state and lowering the fork to the bottom position. 1 Toe board 2 Rubber cover 5 Set bolt Removal Procedure 1 Remove the toe board. 2 Remove the rubber cover 3 Disconnect the control valve lever link. 4 Disconnect the piping. 5 Remove the oil control valve set bolt. 6 Remove the oil control valve ASSY. Installation Procedure The installation procedure is the reverse of the removal procedure. Note: Apply grease the oil control valve lever link parts.
Check the hydraulic oil level, and add if insufficient.