Toyota — Clutch

REMOVAL - INSTALLATION T = 7 N.m (kg-cm) [ft-lbl 1 Toe board J Removal Procedure 1 Remove the toe board. 2 Remove the clutch housing cover. 3 Remove the lock ring. [Point 11 4 Disconnect the clutch release cylinder push rod. 5 Disconnect the release shaft lever return spring. 6 Install service bolts (3 pcs.) on the clutch cover. [Point 21 7 Remove the clutch cover set bolts. 8 Remove the clutch disc. [Point 31 9 Remove the clutch cover. [Point 41 10 Remove the release hub Wlbearing. [Point 51 Installation Procedure The installation procedure is the reverse of the removal procedure. Note: Apply a small amount of chassis grease on the input shaft spline portion.

Always remove the service bolts (3 pcs.) after installing the clutch cover.